In the majority of situations, most people spend quite a lot of money buying their lift truck. Thus, it is really important to take good care of it so as to protect your investment well into the long run. It is a good idea to know the procedures that are carried out in taking care of and maintaining this machine.
By starting up the forklift and listening closely how it works is among the best ways to tell how good the engine is running. Like for example, if there are any knocks or misses, the machinery is defective and this should raise some issues. In addition listen closely for any squealing sounds that come from the belts since these noises will provide you with a wealth of information.
When doing maintenance, some of the main components you would have to pay attention to comprise the horn, safety warning devices, the overhead guard, the lights and the gauges. Any burnt out light bulbs or faulty components have to be replaced as soon as they are noticed. It is also vital to check the wiring.
The battery compartment terminals must be cleaned when the above components have been inspected carefully. If the terminals are not clean, be sure to clean them properly. Each battery cell should be inspected in order to make sure that the fill level is topped up to the regulated amount.
An oil change is the next step to drain all the oil out of the machine and then change the filters. The hydraulic filter, the transmission filter and the fuel filters should be frequently replaced. Before fitting them, be sure to write the date on the new filters by utilizing a permanent marker in order to keep track.
Once the oil change has been done and new filters have been fitted, visually check the drive axle from beneath the machine. Be certain to grease the axle if there is any grease fitting. Inspect the belts on the engine for any frays or cracks. If you find any, fix the issue accordingly. After that, inspect every other part of the machine like the wheels. If any kind of fault or issue is detected, be sure to deal with it immediately in order to make sure the equipment is running at its safest and optimum levels.