It is essential to use extra caution when utilizing a rough terrain scissor lift. Operators must be completely aware of the surrounding environment. Extended booms on the machinery act as levers from the drive units center. For example, a 6 inch bump can cause a 3 foot bounce when the operator is at the driver controls. Consider all other traffic in the vicinity, because they may not know that you are moving. Plan your assent cautiously. Park the boom lift on a flat surface which has no mud or water. These areas conceal deep potholes which could be potentially cause the occupants to fall if the tires fell into the holes. If provided, use all of the outriggers, extended to their full extension position. Be sure to only use approved wooden chalk blocks.
Several lifts will operate from the end of the boom on a metal platform. Extended booms act levers on the drive unit. While you are at the driver controls, a 6-inch bump can result in a 3-foot bounce. Be aware of all other traffic. They might not be aware that you are moving. Plan your assent. Park the boom lift on a flat surface free of any mud or water. These areas could cover deep potholes wherein the lift tires could fall, tipping the occupants. Extend all outriggers, if provided, fully. Place just approved wooden chalk blocks beneath the outrigger pads in order to prevent the unit from moving.
A serious hazard for lift operators is overhead power lines. This is due regardless of what type of lift is used. For instance, if the driver of the platform is not being aware, or if the platform is being controlled by ground workers which is not able to accurately access proximity to wiring and therefore, either the platform itself or the worker could be easily brought into contact with electrical wires. The worker could be electrocuted unfortunately unless properly insulated.